Air control for machine tools and automation.
From a loading fixture to an automatic assembly station, pneumatic components prepare the air, switch its direction and move the mechanism. Start with the job at the tool, then work back to the air supply.
Where pneumatics fit.
Clamping and locating
A cylinder can move a clamp or locating stop into position. Define the required holding force, travel and fixture geometry before choosing the actuator.
Loading and part transfer
Pushers, stops and transfer mechanisms need controlled linear travel. Consider the workpiece mass, cycle time and how the load is guided.
Air supply at the machine
Local filtration and pressure regulation prepare the supply for the valve and actuator circuit. Select flow capacity for the motions that run together.
Components to consider.
Explore the product range, then check the model specifications for your circuit.
HDA air preparation
Prepare the machine supply
Filters, regulators and modular combinations provide a starting point for the air-supply circuit. Choose the configuration, gauge and drain for the installation.
HVF solenoid valves
Switch actuator direction
Directional valves route compressed air to the actuator. Match single- or double-solenoid operation, coil voltage and wiring to the machine controls.
HC95 cylinders
Move the load
Tie-rod cylinders provide linear motion. Select bore, stroke, mounting and piston options from the load and machine layout.
Before you choose.
Use these details to narrow the selection with XMC.
- Force and travel
- Required force, stroke, workpiece mass and mounting orientation.
- Motion and cycle
- Cycle time, simultaneous movements, guidance and stopping method.
- Air and installation
- Available pressure, peak flow, port size and space around the assembly.
- Machine controls
- Coil voltage, connector choice and any position-feedback requirements.
Guides for this application.
- HDAL Lubricator Minimum Flow: Why Is the Oil Not Dripping?
- Two-Piece vs Three-Piece FRL: Choosing an XMC HDA Combination
- FRL Installation Checklist: Airflow, Drainage and Commissioning
- Air Regulator vs Precision Regulator: How to Choose
- Air Filter vs Mist Separator: When Is 5 Micron Not Enough?
- When to Replace a Pneumatic Air Filter Element
- Water After an Air Filter: When Does Your System Need a Dryer?
- 5 vs 25 vs 50 Micron Pneumatic Filters: How to Choose
- Air Regulator Pressure Drops Under Load: Causes and Checks
- Manual vs Automatic Air Filter Drain: How to Choose for HDA
Talk through your application.
Send a fixture sketch, the required motion and force, available air pressure and target quantity.